| 电动伸缩门的注意事项 |
| 添加时间：2023/9/28 15:19:49 浏览次数： |
| 电动伸缩门的注意事项 Precautions for electric telescopic doors 要想伸缩门具有报警功能，就要安装报警探头，这一方面用户可根据报警的实际情况选配报警探头。 If you want the telescopic door to have an alarm function, you need to install an alarm probe. In this regard, users can choose to equip an alarm probe according to the actual situation of the alarm. 2、报警探头输出信号接口的类型应为继电器输出接口，供电电压应为直流12—15V,否则不能由本控制器直接供电。探头耗电应≤100毫安。所以用户可根据现场的实际使用情况选择是否配用多只探头（一般以1到2只为宜）。同时安装完毕后，应避免其他热源或直射光影响，伸缩门上的报警探头应加防雨罩。 2. The type of alarm probe output signal interface should be relay output interface, and the power supply voltage should be DC 12-15V, otherwise it cannot be directly powered by this controller. The power consumption of the probe should be ≤ 100 milliamperes. So users can choose whether to use multiple probes based on the actual usage on site (usually 1-2 probes are recommended). After installation, other heat sources or direct light should be avoided, and the alarm probe on the telescopic door should be equipped with a rain cover. 3、延时自动停机功能可根据用户的门体行程设置，出厂时设定为145秒左右。 3. The delayed automatic shutdown function can be set according to the user's door travel, and is set to around 145 seconds at the factory. 4、发现开门和关门方向相反时，将控制器的“V”和“W”端子接线对调即可。同样，STOP显示屏指示方向与实际相反时，可依照前面同样的方法进行调整。 4. When it is found that the opening and closing directions are opposite, simply switch the wiring of the "V" and "W" terminals of the controller. Similarly, when the direction indicated on the STOP display screen is opposite to the actual direction, adjustments can be made using the same method as before. 5、如果遇到控制器发生故障，小编建议大家寻找专业人员进行维修或与供货方和生产厂联系维修。不要擅自拆卸修整，避免造成更大的损坏。 5. If there is a malfunction in the controller, the editor suggests that everyone seek professional personnel for maintenance or contact the supplier and production factory for maintenance. Do not dismantle or repair without authorization to avoid causing greater damage. 6、控制器要一直保持干净的状态，不要让水或其他有害物质腐蚀控制器（机壳清洁严禁使用有机溶剂）。 6. The controller should always be kept in a clean state and should not be corroded by water or other harmful substances (organic solvents are strictly prohibited when cleaning the casing). 7、伸缩门的电缆芯数一般不应少型线 流水槽模具 景观石 检查井钢模具 保定通风管道 隔离墩模具 保定保洁公司于8线，门体电缆的中间不能含有接头。 7. The number of cable cores for expansion doors should generally not be less than 8, and there should be no joints in the middle of the door cable. 8、遥控发射器应保持干净的外表，不可被挤压、振动、跌落、进水。定期注意、检查电池电压，需要更换时一定要及时更换，比如当可遥控的范围距离过近时，就需要更换电池。 8. The remote transmitter should maintain a clean appearance and should not be squeezed, vibrated, dropped, or flooded. Regularly pay attention to and check the battery voltage, and be sure to replace it in a timely manner when necessary. For example, when the remote control range is too close, the battery needs to be replaced. |
| 上一页 风管加工 |
| 下一页 目前，我国从事电动门生产的企业有数千家 |
Copyright © 技术支持：遨游网络